JVC MP-XV941DE, MP-XV841US, MP-XV841GBEX CON5, Removing the hinge coverSee , , Figure

Page 5

3.1.5Removing the hinge cover(See Figure 7 ,Figure 8, Figure 9)

(1) Remove one screw C and two screws B from the hinge cover.

C :short D :long

(2)Disconnect one card wire from the connector CON5 on the main board.

(3) Remove one screw E from the bottom of the main unit.

(4)Leave the LCD panel open. Release four tabs g on the hinge cover by slowly inserting a single-slotted or flat screwdriver into the slot of the battery terminal.

*Please make sure not to damage either the hinge cov- er or the bottom case when releasing the tabs.

(5)Slowly remove the hinge cover in the direction indicted by the arrow.

CON5

Hinge cover	C D
	C D
	Fig.7
	E

Fig.8

Tab g Tab g

Bottom case

Tab g

Hinge cover Battery terminal LCD Panel assembly

Fig.9

(No.XE003)1-5

Image 5

Contents MP-XV941DE, MP-XV841DE, MP-XV841GB,MP-XV841GBEX, MP-XV841US Section Precaution Specific Service Instructions Gap a Disassembly procedure Removing the Dimm coverSee FigureRemoving the DVD drive unitSee Figure Removing the fittingSee , FigureLatch f Removing the keyboard assemblySee , ,FigureKeyboard Main board Keyboard CON6Removing the hinge coverSee , , Figure CON5Removing LCD panel assemblySee and Figure Main Terminal Main board Wireless LAN boardCON2 AUX Terminal FCON4 CON10 Shield plateTab h Main board CON3Removing the hard disc drive Removing the built in memory card and wireless LAN cardRemoving the parts on the main boardSee and Figure LCD Cushions and P TabLAN Antenna CN2Section Adjustment Procedure Section TroubleshootingAre your sure to replace BIOS? Y/N Y Please input file name of new BiosDevice List License AgreementDiagnosis on HDD Following materials are needed. Provision from JVCTest Results Advance TestConfirmation ExitSerial label Main board replacing procedureRemoving the serial label Operation check item list after the repair is completedWPC

Related manuals

Manual 114 pages 54.01 Kb