3.1.6Removing LCD panel assembly(See Figure 10 and Figure 11)
• Prior to the following procedure, the keyboard assembly and the hinge cover should be removed.
(1) Disconnect each wire from the connectors CON2 and CON9 on the main board.
(2) Remove two wires from the connector on the wireless LAN board.
*Connect grey wire to the AUX terminal, and black wire to the MAIN terminal for reassembly.
(3) Remove two screws F which are attached to the hinge.
(4)Remove two screws G which are attached to the hinge from the bottom of the main unit.
(5)Pull out the hinge by moving the LCD panel unit upward.
| CON2 |
F | AUX Terminal F |
CON9 |
| MAIN Terminal |
|
|
| ||
Main board | Wireless LAN board | ||
|
| Fig.10 | |
G |
| G | |
Fig.11