Knoll Systems HDO2200 user manual Adjusting the Projector Level

Page 20

DLP Projjjectttor – User’s Manualll

Adjusting the Projector Level

Take note of the following when setting up the projector:

The projector table or stand should be level and sturdy.

Position the projector so that it is perpendicular to the screen.

Remove the Back Foot Holder on the rear adjuster foot before adjusting the projection angle.

Ensure the cables are in a safe location. You could trip over them.

1.

2.

3.

To raise the level of the projector, lift the projector [A] and press the height-adjuster button [B].

The height adjuster drops down [C].

To lower the level of the projector, press the height-adjuster button and push down on the top of the projector.

To adjust the angle of the picture, turn the tilt-adjuster [D] right or left until the desired angle has been achieved.

13

Image 20
Contents HDO2200 Copyright Symbols Used General Safety InformationProjector Installation Notice Power SafetyCleaning the Projector Important Recycle Instructions Symbol ExplanationsReplacing the Lamp Regulatory WarningsTable of Contents Regulatory Compliance Packing Checklist Getting StartedFront-right View Views of Projector PartsTop view-On-screen Display OSD buttons and LEDs BlankRear view VGABottom view Remote Control Parts DLP Projector User’s Manual Remote Control Operating Range Projector and Remote Control ButtonsSetup and Operation Inserting the Remote Control BatteriesConnecting Input Devices Label DescriptionStarting and Shutting down the Projector DLP Projjjectttor-User’s Manualll Adjusting the Projector Level Adjusting the Zoom ring, Focus and Keystone Use the Image-focusAdjusting the Volume Navigating the OSD OSD Menu ControlsSetting the OSD Language OSD Menu Overview PICTUREBasic Menu PICTUREAdvanced Menu HSG Adjustment Press the Enter button to enter the HSG Adjustment sub menuDisplay Menu PC Detail Adjustment SETUPBasic Menu Menu Settings SourceLan Control Settings Network StateDLP Projjjectttor User’s Manualll DLP Projjjectttor-User’s Manualll Select OSD ´ Setup ´ Network ´ Enabled Category Input -LENGTH DLP Projjjectttor User’s Manualll SETUPAdvanced Menu Audio LampHdmi Closed CaptionPresentation Timer Status Menu Maintenance and Security Replacing the Projection LampDLP Projjjectttor-User’s Manualll Cleaning the Projector Cleaning the LensCleaning the Case Using the Kensington Lock Common problems and solutions Tips for TroubleshootingLED Error Messages Image ProblemsLamp Problems Remote Control ProblemsProblem The image is flat with no contrast Problem There is no light from the projectorAudio Problems Having the Projector ServicedProblem There is no sound Problem The sound is distortedHow do I run Hdmi cables longer than 10 meters? How can I tell if a cable is an Hdmi certified cable?Specifications SpecificationsProjection Distance and Size Table Projection Distance vs. Projection SizeTiming Mode Table RGB Hdmitm KHZ VideoRGB Hdmi TM KHZ Video Projector Dimensions Regulatory Compliance