Onkyo HT-S6100 Changing the Input Display, Press the Tape input selector, On the display

First Time Setup—Continued

2 Use the Up and Down []/[ ] buttons to select “1. Input Assign,” and then press [ENTER].

the“Automatic Audio Input Selection Setup” on page 49 to the same input (e.g., COAX1 (Auto) or COAX2 (Auto)).

•This procedure can also be performed on the AV receiver by using its [SETUP], [ENTER], and arrow buttons.

3 Use the Up and Down []/[ ] buttons to select “3. Digital Audio Input,” and then press [ENTER].

4 Use the Up and Down []/[ ] buttons to select an input selec- tor, and then use the Left and Right []/[ ] buttons to select: COAX1: Select if the component is

connected to DIGITAL IN COAXIAL 1.

Changing the Input Display

If you connect an -capable Onkyo MiniDisc recorder

or CD recorder to the TAPE IN/OUT jacks, for to work properly, you must change this setting.

This setting can only be changed on the AV receiver.

1, 2

MASTER VOLUME

ON/STANDBY

TUNING

PRESET

STANDBY

DOCK

MULTI CH

DVD

VCR/DVR

CBL/SAT

AUX

TAPE

TUNER

CD

SETUP

RETURN

AUX INPUT

PHONES

SETUP MIC

VIDEO

L AUDIO R

A SPEAKERS B

TONE

MOVIE/TV

MUSIC

GAME

DISPLAY

DIGITAL INPUT

DIMMER

MEMORY TUNING MODE

LISTENING MODE

AV RECEIVER HT-R667

1	Press the [TAPE] input selector
	button so that “TAPE” appears
	on the display.
	TAPE

COAX2: Select if the component is connected to DIGITAL IN COAXIAL 2.

OPT1: Select if the component is connected to DIGITAL IN OPTICAL 1.

OPT2: Select if the component is connected to DIGITAL IN OPTICAL 2.

- - - - -:Select if the component is connected to an analog input.

5	Press the [SETUP] button.
	Setup closes.

Notes:

•When an HDMI IN is assigned to an input selector in “HDMI Input Setup” on page 46, this input assign- ment is automatically set to the same HDMI IN. And in addition to the usual inputs (e.g., COAX1, COAX2, etc.), you can also select HDMI inputs. If you change the input assignment from an HDMI IN to one of the other inputs (e.g., COAX1 or COAX2), be sure to set

2

TAPE

Press and hold down the [TAPE] input selector button (about 3 seconds) to change the setting.

Repeat this step to select MD or CDR.

For the TAPE input selector, the setting changes in this order:

TAPE → MD → CDR →

48