Bosch Appliances FPE-1000-NF, FPE-1000-NE, FPE-1000-NW Connection, Class a connections

Page 13

Networking CardsConnection en 13

5

Connection

5.1

General considerations

 

 

 

NOTICE!

 

All wiring except the battery terminal and primary AC power is power-limited. Phone lines are

also generally considered to be nonpower-limited.

Power-limited and nonpower-limited circuit wiring must remain separated in the cabinet by at least 0.25 in. (64 mm) and must enter and exit from the cabinet through different knockouts or conduits. Phone lines are generally considered to be nonpower-limited, so the cables for networking cards should not be run through the same knockout as the phone lines.

Avoid shielded or twisted-pair wire except for special applications where a reduced length of wiring (roughly 50%) is acceptable for tolerating a harsh electrical environment. Consider fiber optics for these applications.

A network group can be connected as Class A Style 7 or Class B Style 4. Class A configuration is recommended because this allows the panels in a network to communicate with each other, ensuring circuit operation in the event of a single break in the wiring.

The following table lists the trouble conditions that result when a fault exists on the network (SLC according to UL 864).

 

 

Type of Fault

Class B Style 4

Class A Style 7

 

 

 

 

 

 

 

Single Open

Trouble

Alarm, Trouble

 

 

 

 

 

 

 

Single Ground

Alarm, Trouble (ground)

Alarm, Trouble (ground)

 

 

 

 

 

 

 

Short

Trouble

Alarm, Trouble

 

 

 

 

 

 

 

Short and open

Trouble

Trouble

 

 

 

 

 

 

 

Short and ground

Trouble

Alarm, Trouble

 

 

 

 

 

 

 

Open and ground

Trouble

Alarm, Trouble

 

 

 

 

 

 

 

Communication loss

Trouble

Trouble

 

 

 

 

 

 

 

Trouble = The control panel will indicate a trouble condition for this type of fault.

 

 

Alarm = The control panel must be able to process an alarm input signal in the presence of

 

 

this type of fault.

 

 

 

 

 

 

 

 

 

Table 5.1 Network Trouble Conditions

 

5.2

Class A connections

 

 

 

 

In a Class A loop, the FPE-1000-NW Wired Networking Card must be wired accoring to the

 

 

following table:

 

 

Bosch Security System, Inc.

Installation Manual

F.01U.214.374 01 2012.08

Image 13
Contents Networking Cards Page Documentation Availability Note 01U.214.374 01 Bosch Security System, Inc Table of Contents General SafetyDisclaimer Networking Cards Safety en Wired Networking Card Type Number Description Connection Mode Maximum DistanceSystem Overview Ethernet Networking CardPlanning Ground Fault DetectionGeneral considerations Port supervisionOperation Guide Mounting InstallationNetworking Card Connectors and slot Snap-fit hook Connection Type of Fault Class B Style Class a StyleClass a connections Network Connections Example Terminal Specifications Class a StyleFPE-1000-NW Wired Networking Card parameters Technical DataCommon parameters of all three networking cards FPE-1000-NE Ethernet Networking Card parametersPage Page Page Page Bosch Security System, Inc