List of Hardware Items for Operation | Texas Instruments TS3USB221

www.ti.com

Introduction

2Introduction

The TS3USB221/A/E EVM is an evaluation module for the Texas Instruments (TI) 1:2 multiplexer/demultiplexer high-bandwidth USB switches. It is specially designed for high-speed USB 2.0 signals, supports bidirectional signaling, and offers high-bandwidth (1.1 GHz). When interfacing other USB devices with this EVM, the switch allows signals to pass with minimum edge and phase distortion as well as little or no signal attenuation.

This evaluation module is designed to demonstrate the small printed circuit board (PCB) areas that can be achieved when designing with the TS3USB221/A/E USB switches. It is powered from the 5-V rail of the USB input. Additionally, the TS3USB221/A/E provides an output enable input and an output select input for flexible configuration of the USB. See Figure 1 for the EVM block diagram.

TS3USB221/A/E EVM

TS3USB221/A/E

Figure 1. TS3USB221/A/E EVM Block Diagram

2.1List of Hardware Items for Operation

The following items are required for EVM evaluation:

•The TS3USB221/A/E EVM

•USB cables with connector type depending on the surrounding system

The following items are optional for EVM evaluation:

•USB type A or type B connectors to change connectors J1 through J5 for optimal system interface configuration

•IBM compatible PC with USB 2.0 ports for quick start evaluation

SCDU001A –July 2009 –Revised October 2009 TS3USB221/A/E High Speed USB 2.0 (480 Mbps) 1:2 Multiplexer/Demultiplexer 3

Submit Documentation Feedback	Switch Evaluation Module