NI223Plus | - 9 - |
3.4.3C-Soft Phone Control Buttons
Figure 6 C-Soft Phone Control Buttons Setup
Figure 6 shows a few of the basic C-Soft Phone Control buttons. Any button can be configured for a task by Right-Clicking on the button, then using the UI Element Function pull down menu. In this case, Phone – On/Offhook was selected. The Remote Phone Line Select tab shows that no specific line was selected as the Phone asset. Instead Pool was selected. In the case of the IP-223, Pool mode means that if both lines are setup as Phone Mode (PSTN or iDen® System), the open line will be selected for use when the console tries to connect. This is the same function as the multi-line telephone. Also shown is an example of a few phone control buttons. Please refer to the C-Soft manual for further details on the button configuration.
3.4.4C-Soft Radio Line Types:
To use the
4 IDen® Network Calling
4.1Console Selected Calling
As shown in Figure 2, each Function Tone entry is assigned a Direct Connect, Group, Emergency, or Alert number. Pressing the Function Tone on the console will route the dial string to the iDen® phone.
4.2Manual Connections
The console DTMF keypad may be used to manually initiate Group, Emergency Group, Direct Connect, Direct Connect, Alert calls or dial a phone number. Using the standard keys, enter the dial string to be called. The A, B, C, or D keys are used to complete the calling function.