Sharp PG-D40W3D Setting and Adjusting, Setting the Security, Projector Settings & Adjustments

Controlling the Projector via LAN

Setting and Adjusting the

Projector (Settings & Adjustments)

Example: “Picture” screen display for COMPUTER1

On these screens, you can make projector settings or adjustments. You can set or adjust the following items:

• Picture Mode	• Projection Mode
• CLR Temp	• DLP® LinkTM
• BrilliantColorTM	• DLP® LinkTM Invert
• Progressive	• Video Setup
• DNR	• OSD Language
• Eco + Quiet Mode	• Auto Sync
• Resolution Setting	• Auto Power Off
• Signal Type	• Auto Restart
• Video System	• System Sound
• Dynamic Range	• Audio Out
• Resize	• Internal Speaker
• Overscan	• Audio Input
• OSD Display	• RS-232C Speed
• Background	• Fan Mode
	• All Reset

Note

•If you click the “Refresh” button before the screen is displayed completely, an error message (“Server Busy Error”) will be displayed. Wait for a moment and then operate again.

•You cannot operate this page while the projector is warming up.

•For details about each item, refer to the projector's operation manual.

Setting the Security

(Network – Security)

On this screen, you can make settings relating to security.

	Items	Description
User Name		Setting of user name for security
		protection.
Password		Setting of password for security
		protection.
Accept IP		It is possible to set up to three IP
Address		addresses allowing connection to the
		projector.
	All IP	No limits are set to IP addresses
	Addresses	connecting to the projector.
	From only	For security improvement, only an IP
	specific IP	address set by “Address 1-3” can be
	addresses	connected to the projector.

Note

•User Name and Password can be up to 8 characters.

•You can input the characters below: a-z, A-Z, 0-9, -, _

-18