Onkyo TX-DS474 appendix Speaker setup, Test Tone Remote controller only, Parameter selector

Speaker setup

6 PARAMETER SELECTOR

6. Press the PARAMETER SELECTOR® button to display the

front speaker position parameter, and press the PARAME-

TER CONTROLLER √/® button repeatedly to set the dis-

tance value from your listening position to the front speaker.

7

PARAMETER CONTROLLER

PARAMETER SELECTOR

PARAMETER CONTROLLER

Pressing the PARAMETER CONTROLLER® button repeatedly

increases the value.

Pressing the √PARAMETER CONTROLLER button repeatedly

decreases the value.

Set the value closest to the actual distance.

7. Press the PARAMETER SELECTOR® button and use the

PARAMETER CONTROLLER √/® buttons to set the

center speaker position parameter.

You cannot set the following values:

•

8 PARAMETER SELECTOR

PARAMETER CONTROLLER

9, 10

PARAMETER SELECTOR

dB

or

dB

PARAMETER CONTROLLER

11 PARAMETER SELECTOR

1, 3	TONE
	TEST

2

CH SEL

TEST

TONE

dB

LEVEL

•	Values larger than the front speaker position setting
	Values smaller than the value obtained by subtracting “5ft”
	from the front speaker setting
8. Press the PARAMETER SELECTOR® button and use the
PARAMETER CONTROLLER √/® buttons to set the sur-
round speaker position parameter.
You cannot set the following values:
•	Values larger than the front speaker position setting
•	Values smaller than the value obtained by subtracting “15ft”
	from the front speaker setting
9. Press the PARAMETER SELECTOR® button to display
the LFE LEVEL ATT parameter.

10.Press the PARAMETER CONTROLLER √/® buttons to select 0 or –10dB.

In general, leave this parameter set to 0dB.

When Dolby digital sound is played and if the bass range is too loud, set this parameter to “–10dB” to decrease the Low Fre- quency Effect in the low frequency channel by 10dB.

11.Press the PARAMETER SELECTOR® button to return to the original display.

Test Tone (Remote controller only)

Use the remote controller and produce the test tone to adjust the level of the connected speakers.

1.Press the TEST TONE button.

Each speaker produces the test tone (pink noise) in the follow- ing order:

L (Front L ch)	C (Center ch)	R (Front R ch)
SW (Subwoofer)	LS (L-Surround)	RS (R-Surround)

2.To adjust the level of each speaker, press the CH SEL button to select a speaker and press the LEVELπ/† buttons to raise or lower the level.

The test tone should sound at the same level when you hear it in your listening position. You can adjust the level in the range between –12dB and +12dB.

3.Press the TEST TONE button to complete adjustment.

Parameter selector

This chart shows how the display changes when the PARAMETER SELECTOR buttons are pressed. Selecting a parameter and pressing the PARAMETER CONTROLLER button will change the value or setting for the selected parameter.

START	Subwoofer	YES / NO
	PARAMETER SELECTOR	PARAMETER SELECTOR

FRONT Speaker LARGE / SMALL

Center Speaker YES / NO

Surround Speaker YES / NO

FRONT Speaker Distance

1 ~9m, 0.3 ~ 30ft

Center Speaker Distance

1 ~9m, 0.3 ~ 30ft

Surround Speaker Distance

1 ~9m, 0.3 ~ 30ft

LFE Level Attenuator

0 / –10dB

QUIT

15