1 |
| |
Basic Printing | (part 2) |
If the tray runs out of paper during printing
Add paper to the tray or press the [TRAY SELECT] key (
) to select a different tray, and then press the [ON LINE] key ( 
) to resume printing. Note that if the "Auto tray switching" setting in the user programs is enabled and there is the same size of paper in another tray, the machine will automatically switch to the other tray and continue printing.
Pausing a print job
To pause a print job during printing, press the [ON LINE] key ( 
) on the operation panel to switch the machine
●To cancel a print job, press the [CLEAR] key (
) or the [CLEAR ALL] key (
).
●To resume printing, press the [ON LINE] key ( 
) to switch the machine online.
Caution | When the machine is connected to your computer using | |
the USB 2.0 | ||
| ||
| "System requirements for USB 2.0 | |
| the Operation Manual. |
When "Paper Source" is set to "Auto Select"
If "Paper Source" is set to "Auto Select" in the "Paper" tab of the printer driver setup screen and the correct size of paper for a print job is not loaded in the machine, the printing procedure will vary depending on the "Use Close Paper Size" setting in the user programs (see "USER PROGRAMS" in the Operation Manual).
When "Use close paper size" is disabled
The PAPER SIZE indicator on the |
|
|
|
|
| ||
|
|
|
|
| |||
operation panel will blink. You can press |
| A3 | |||||
the [TRAY SELECT] key ( ) to select a |
| ||||||
| A4 | ||||||
tray manually, or load paper in the |
| A4 |
|
|
| ||
|
|
| |||||
|
|
|
| ||||
bypass tray and press the [ON LINE] |
| A5 | |||||
| B4 | ||||||
key ( |
| ) to begin printing. |
| EXTRA | |||
|
| ||||||
*The | paper sizes that appear in the |
|
|
|
|
| |
|
|
|
|
| |||
operation panel will vary by country and region. |
|
|
|
| |||
When "Use close paper size" is enabled
Printing will take place using a size of paper that is close to the size of the print image.
● When the dual function board is installed, the print image is
Note | automatically rotated to fit the paper in the event that the paper |
| |
| is loaded in an orientation different from the print image. |
●If the dual function board is not installed, be sure to set each tray's paper size in "Set Tray Status" in the "Configuration" tab of the printer driver setup screen. (See "CONFIGURING THE PRINTER DRIVER" in the Software Setup Guide.)
When printing, be sure to specify a tray other than "Auto Select" in "Paper Source" in the "Paper" tab of the printer driver setup screen.
CONTENTS | I N D E X | 6 |
|
|
|