SMC Networks SMC7004ABR, S M C 7 0 0 4 A B R manual System Requirements, Lan

Installing the Router

Item	Description
Reset	Use this button to reset the power and restore the default
Button	factory settings.
LEDs	Power, WAN and LAN port status indicators.
	(See “LED Indicators” on page 1.)
LAN	Fast Ethernet ports (RJ-45). Connect devices (such as a
Ports	PC, hub or switch) on your local area network to these
	ports.
Printer	Parallel port (25-pins, D-type, female). Connect the shared
Port	printer to this port.
WAN	WAN port (RJ-45). Connect your cable modem, DSL
Port	modem, or an Ethernet router to this port.
COM	Serial port (9-pins, D-type, male). Connect your ISDN TA or
Port	56K analog modem to this port.
Power	Connect the included power adapter to this inlet.
Inlet	Warning: Using the wrong type of power adapter may
	cause damage.

System Requirements

You must have an ISP that meets the following minimum requirements:

•Internet access from your local telephone company or Internet

•

•

Service Provider (ISP) using a DSL modem, cable modem, ISDN TA, or PSTN analog modem. You may also have access over the telephone system to an analog modem at another site.

A PC using a fixed IP address or dynamic IP address

assigned via DHCP, as well as a Gateway server address and DNS server address from your service provider.

A computer equipped with a 10 Mbps, 100 Mbps, or

10/100 Mbps Fast Ethernet card, or a USB-to-Ethernet converter.

6