Technicolor - Thomson MS4200 Maintenance, CD Player Tape Player, Cleaning CDs, CD Lens Care

Page 22
Side A Protection Side B Protection
A B

MS4200 EN 2/3/04 9:54 AM Page 23

Maintenance

Disconnect the audio system from the power source before performing any maintenance.

Cleaning

Clean the exterior of the system using a soft dust cloth.

Handling CDs

EN

Do not touch the signal surfaces. Hold CDs by the edges, or by one edge and the hole.

Do not affix labels or adhesive tapes to the label surfaces.

Do not scratch or damage the label.

CDs rotate at high speeds inside the player.

Do not use damaged (cracked or warped) CDs

CD Player

CAUTION! This system operates with a laser. It must be opened by only a qualified technician.

Tape Player

To prevent deterioration of sound quality, periodically open the door of each deck and clean the magnetic heads, pinch roller, and capstan with a cotton bud dipped in alcohol. Also, demagnetize the head by playing a demagnetizing cassette (available through an audio equipment store).

To protect recordings one or both sides of a tape, remove the corresponding tab. If you later want to record on

the tape, affix a piece of adhesive tape over the

hole.

 

Quit Slacking - A little bit of

 

slack in your tapes can cause

 

scratches on the tape, or

A

worse yet, the tape could

 

break. If you notice some

 

slack in the tape, use a pencil

 

to tighten it up before you insert it.

 

Cleaning CDs

Dirty CDs can cause poor sound quality. Always keep CDs clean by wiping them gently with a soft cloth from the inner edge toward the outer perimeter.

If a CD becomes dirty, wet a soft cloth in water, wring it out well, wipe the dirt away gently, and then remove any water drops with a dry cloth.

Do not use record cleaning sprays or antistatic agents on CDs. Also, never clean CDs with benzene, thinner, or other volatile solvents which may cause damage to disc surface

CD Lens Care

When your CD lens gets dirty it can also cause the system to output poor sound quality. To clean the lens you will need to purchase a CD lens cleaner which can maintain the output sound quality of your system. For instructions on cleaning the CD lens, refer to the ones accompanying the lens cleaner.

18

Image 22
Contents Thomson MS4200 Safety Information EN For UK OnlySee Marking on Bottom / Back of Product Table of Content Unpacking the system InstallationGetting Started Back ViewEN Main Unit PROG/SET Enters program mode for CD and TunerGeneral Controls Front ViewPhones Jack for connecting headphones Tape mode Rewinds tapeTop View Tuner mode Selects next/ previous preset station EN Remote ControlOr Decreases or Increases volume Display Installing BatteriesRepeat 1 Repeat track Setting the Timer SettingsSetting the Clock Activating the TimerSound Features CD-RW/ CD-R discs for CD PlayerEN Important CD and mp3 Information PlaybackStop Playback Loading DiscsPlay and Pause Discs Play and load simultaneously byCD Information EN Selecting a DiscSearching Through a CD Sampling TracksDisplay Program List Setting Up a CD ProgramPlaying a Program List Edit Program ListRadio Displaying RDS Station Information Tuning to an RDS StationAlarm alarm Remote OnlyPlaying a Tape Tape PlayerEN Selecting Tape Player Tape CounterTroubleshooting Tips Problem SolutionIs out of folders and songs from level 3. order Cleaning CDs MaintenanceCleaning CD Player Tape PlayerImportant Information