ENGLISH
OPERATION
USING THE C 715 – EXTERNAL SOURCES AND timer
Listening to External Sources |
| SETTING THE ON/OFF TIMER | ||||||
When appropriately connected to the applicable C 715 input, one can listen |
| Adjust the clock before setting the timer. | ||||||
to external sources such as a VCR, Media Player (MP), Tape Recorder and |
| 1 Toggle [TIME MODE] until “On time” is displayed in the VFD. At “On time” | ||||||
other auxiliary components. |
| mode, “hour” value blinks. | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FRANÇAIS
ESPAÑOL
ITALIANO
DEUTSCH NEDERLANDS SVENSKA
РУССКИЙ
Toggle the [SOURCE] button to select [TAPE], [VIDEO], [AUX] or [MP] mode. Refer to the above sections about “Identification of Controls – Front Panel” and “Identification of Controls – Rear Panel” for additional information on these external sources.
SETTING THE CLOCK
1Press the [TIME MODE] button. Toggle [TIME MODE] to step through the following modes:
Current time
On time
Source Select
Off time
2At “Current time” mode, toggle [TUNE / TIME] to set the current hour
– “hour” value blinks. Press [TUNE MODE/SELECT].
3“Minute” value blinks. Press [TUNE/TIME] to set the current minute. Press [TUNE MODE/SELECT]. The clock starts from “00” seconds.
NOTES
•The C 715 uses the 24 hour “military” clock.
•When no action is taken for 1 minute, the time adjust mode is cancelled.
•To cancel time mode setting, press [STOP].
2Toggle [TUNE/TIME] to set the desired “hour” setting. Press [TUNE MODE/SELECT].
3“Minute” value blinks. Press [TUNE/TIME] to set the desired “minute” setting. Press [TUNE MODE/ SELECT].
4“Off time” appears on the VFD and “hour” value blinks. Repeat steps 2 and 3 above to set desired “Off time”.
5Press [TUNE/TIME] to select the SOURCE where these timer settings will be applied.
6Press [TUNE MODE/SELECT]. Timer settings are now stored in the memory.
18