Using the C 715 Other Features

ENGLISH

OPERATION

USING THE C 715 – OTHER FEATURES

TONE/BALANCE/DIMMER		OTHER SR 7 FEATURES
Toggle this button to adjust tone, balance and dimmer settings in		Most of the buttons on the remote control handset have the same effect as
combination with [VOLUME] knob. Toggle [TONE/BAL/DIMMER] to step		the corresponding buttons on the front panel of the C 715. In addition, the
through the following modes:		handset is equipped with some extra buttons like the following function
		keys.
	BASS TREBLE BALANCE DIMMER
	BASS TREBLE BALANCE DIMMER
		NUMERIC KEY PAD
		NUMERIC KEY PAD

FRANÇAIS

ESPAÑOL

ITALIANO

DEUTSCH

Select the feature you want to adjust and within 3 seconds, turn [VOLUME] clockwise or counterclockwise to change the level settings.

Tone ControlS – Treble and Bass

Treble and bass controls only affect the low bass and high treble leaving the critical midrange frequencies free of coloration.

These controls allow one to tweak on-the-fly, the frequency response of the source during playback.

Maximum and minimum values for both Tone Control levels are +/- 10 dB.

Balance

The BALANCE control adjusts the relative levels of the left and right speakers. The “BALANCE CENTER” position provides equal level to the left and right channels. Rotating the control clockwise moves the balance towards the right. Rotating the control anti-clockwise moves the balance to the left.

Dimmer

Toggle to either reduce or restore normal VFD brightness.

Using the direct-entry numeric keypad (0 to 9) causes the C 715 to jump directly to the beginning of a numbered track and commence play. Thus, to play Track 5, simply press “5”. To play Track 20, press “2” and “0”.

REPEAT

To repeat the playback of a particular track or file, press the SR 7’s [REPEAT] key once. Toggle the [REPEAT] key to repeat all the tracks, files, folders or until repeat mode is turned OFF.

Repeat 1 RPT Folder (USB, MP3/WMA disc)

Play (Repeat Off ) Repeat All

NEDERLANDS SVENSKA

РУССКИЙ

REPEAT A-B

To repeat a sequence, implement the following procedures:

1Press [RPT A-B] at your chosen starting point – “RPT A-B” is shown in the VFD. “B” is blinking as it awaits the end point of the repeat sequence.

2Press [RPT A-B] again at your chosen end point. The repeat sequence begins.

3Press [RPT A-B] again to cancel the sequence.