Sharp XEA22SR, TINSZ2601RCZZ, XE-A22S instruction manual Reading X and Resetting Z of Sales Totals

READING (X) AND RESETTING (Z) OF SALES TOTALS

•Use the reading function (X) when you need to take a reading of sales information entered since the last reset. You can take this reading any number of times. It does not affect the register’s memory.

•Use the resetting function (Z) when you need to clear the register’s memory. Resetting prints all sales information and clears the entire memory except for the GT1 through GT3, Training GT, reset count, and consecutive number.

1Summary of Reading (X) and Resetting (Z) Reports

X1 and Z1 reports: Daily sales reports

X2 and Z2 reports: Periodic (monthly) consolidation reports

When you take a X or Z report, turn the mode switch to the appropriate position referring to the column of “Mode switch position” shown on the table below, and use the following corresponding key sequence.

Item	Mode switch position					Key operation
	OPX/Z	X1/Z1	X2/Z2
				Dept. code	d : Department sales total
Flash report:				For dept. 1 to 16; Dept. key ( !to <)
(Only display)
				For dept. 17 to 32; D				Dept. key ( !to <)
To clear the
display, press the	X	--	--
lkey or turn the				@key: Amount of cash in drawer
mode switch to
another position.
				Akey: Sales total
Full sales report	--	X1, Z1	X2, Z2	Reading: A			Resetting: P A
Individual clerk				Reading: L			Resetting: P		L
report	X, Z	--	--
				(The report of the current clerk)
Full clerk report	--	X1, Z1	--	Reading: L			Resetting: P		L
PLU sales report						All PLUs
					Start		@	End	p
				Reading:
	--	X1, Z1	--		PLU code			PLU code
				Resetting:		All PLUs
				Start		@	End		P p
				PLU code			PLU code
Hourly report	--	X1, Z1	--	Reading: s			Resetting: P s

• When both sales quantities and sales amounts are zero, printing is skipped. If you do not want to skip, change the programming. (Refer to “Print format” of “Various Function Selection Programming 1”.)

•“X” represents read symbol and “Z” represents reset symbol in the reports.

•To stop reading and resetting the PLU sales report, turn the mode switch to the MGR position.

The data will not be erased when you reset.

• When printing is performed continuously, the printing may be intermitted several seconds. After 59 the intermission, the printing will be restarted.