Connecting the Barcode Scanner | Sharp TCADH2564RCZZ instruction

XE-A506 Quick Start Guide

English

The following describes how to get the cash register ready for operation. Follow these steps before using the cash register for the first time. Place the cash register on a stable, flat surface not subject to direct sunlight.

1 Connecting the Barcode Scanner

A barcode scanner is provided with the cash register. To use the scanner, connect the scanner before turning on the register.

1.Open the Scanner port cover at the right side of the register.

2.Insert the connector of the

barcode scanner into the Scanner port, and tighten both screws on the connector.

CAUTION: • Always unplug the power cord of the cash register when you connect or disconnect the barcode scanner.

•Never connect devices other than the barcode scanner before changing the interface setting. Otherwise malfunction of the cash register will occur.

2 Initializing the Cash Register

To ensure the cash register operates properly, please use the following procedure:

1. Make sure the power cord plug is not inserted into the AC outlet.			REG
		OPX/Z	MGR
2. Insert the manager (MA) key into the mode switch and turn it to the PGM position.	MA	OFF	X1/Z1


		VOID	X2/Z2

PGM

3.While holding down both the } key and the l key, insert the plug into the AC outlet. The buzzer will sound three times and “***MRS.***” will be displayed.

4. The cash register has now been initialized.

The register display will show “0.00” with “PGM”.

CAUTION: To charge the rechargeable batteries, keep the power on for one or two days. Leave the register with the mode switch in a position other than “OFF”.

NOTE: If you press a key by mistake, an error message may be displayed. Press the lkey to clear message after installing paper rolls.

3 Preparing the Cash Register

4 Installing the Paper Rolls

1. Push the printer cover forward and

detach it.

1.Cut off approximately one revolution of each paper roll. Make sure the paper end is cut as illustrated right.

Correct Incorrect

For journal paper installation

5.	Set a paper roll in the paper cradle of the journal side as
	illustrated in step 2.
6.	Insert the end of the paper into the paper chute until it is

2. Remove the white retainer at the

position shown right.

NOTE: Please keep this retainer for future use when transferring the cash register.

Retainer

For receipt paper installation

2.Set a paper roll in the paper cradle of the receipt side (upper side) as illustrated right.

To the printer

Correct

To the printer

Incorrect

caught by the printer auto-feed and comes out the top of

the printer. If the printer does not catch the paper, feed

the paper while pressing }as illustrated in step 3.

7. Insert the end of the paper into the

slit in the take-up spool and fold

the paper to front side, then wind

the paper two or three turns

3. Move the print head release lever

upwards as illustrated right.

Print head release lever

3.Insert the end of the paper into the

paper chute until it is caught by the printer auto-feed and comes out the top of the printer. If the printer does not catch the paper, feed the paper while pressing }.

4.Cut off the excess paper with the paper cutter.

around the spool shaft. (Press }	Slit
around the spool shaft. (Press }
to feed more paper if required.)

8. Set the spool on the bearing, and press the } key to take up excess slack in the paper.

9.Replace the printer cover.