Sharp XG-PH80W-N, XG-PH80X-N specifications Controlling the Projector via LAN

Controlling the Projector via LAN

After connecting the projector to your network, enter the projector IP address in “Address” on Internet Explorer (version 6.0 or later) using a computer on the network to start a setup screen that will enable control of the projector via the network.

Controlling the Projector

Using Internet Explorer

Complete connections to external equipment before starting the operation. (See pages 21-25 of the projector's operation manual.)

Complete the AC cord connection. (See page 27 of the projector's operation manual.)

Note

•Set “LAN/RS232C” in “Ex. Setting” of the “PRJ-ADJ” menu to “LAN”.

•When connecting the projector to the LAN, use a commercially available LAN cable (UTP cable, Category 5, cross-over type). When connecting the projector to a hub, use a straight-through cable.

1

2

Start Internet Explorer on the computer.

Enter “http://” followed by the projector IP address set by the procedure on page 22 followed by “/” in “Address”, and then press the “Enter” key.

•When “DHCP Client” is set to “Off” on the projector, IP address is 192.168.150.2. If you did not change the IP address in “3. Setting up a Network Connection for the Projector” (pages 22-23), enter “http://192.168.150.2/system.html”.

3A screen for controlling the projector appears, ready for performing various status conditions and control.

-24