Connecting the Projector
Connecting the Power Cord
Plug the supplied power cord into the AC socket on the back of the projector.
Power cord
Setup &
Connections
CAUTION
•Make sure you connect the power cord firmly into the AC socket.
•The configuration of wall outlets differs from country to country. Use the power cord that corresponds to the wall outlet in your country.
Connecting the Projector to a Computer
You can connect your projector to a computer for projection of full colour computer images.
Connecting a computer using the standard 15-pin input
INPUT 1 | OUTPUT (INPUT 1) | ||
AUDIO | COMPUTER | AUDIO | COMPUTER |
Computer RGB cable
Computer audio cable
1Connect one end of the supplied computer RGB cable
to the COMPUTER INPUT 1 port on the projector.
2Connect the other end to the Monitor output port on the computer. Secure the connectors by tightening the
thumb screws.
3 To use the
4Connect the other end to the Audio output terminal on the computer.
CAUTION
•Before connecting, be sure to turn both the projector and the computer off. After making all connections, turn the projector on first. The computer should always be turned on last.
•Please read the computer’s operation manual carefully.
•Refer to page 47 “Computer Compatibility Chart” for a list of computer signals compatible with the projector. Use with computer signals other than those listed may cause some of the functions not to work.
•A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Sharp Authorised LCD Projector Dealer or Service Centre.
12