Sim2 Multimedia 3D-S manual Troubleshooting

Page 35

5 Troubleshooting

The projector does not turn on

•Make sure the main power switch (at the rear of the projector) is in the On position.

•Ensure the projector is connected to an electrical outlet and the outlet is working.

•Check the fuse located near the AC receptacle on the right hand side of the projector.

•Replace the fuse with one of the same type and rating (T 10 A L H 250 V).

•If the fuse blows repeatedly, contact an authorized technical center.

Lamp does not turn on

•If the projector is cooling down (indicator light flashing green and red), wait until cooling is complete. After Standby mode is entered (indicator light solid red), turn projector on again.

•The lamp may have overheated. Check that the air inlets and outlets are not blocked and that room temperature is within specifications. Wait at least 30 minutes and then turn the projector back on.

•Check the Status Display for any errors. Contact your SIM2 Authorized Dealer for assistance if the error persists.

•Lamp may need replacement. Contact your SIM2 Authorized Dealer for assist- ance.

“No Signal” Message is displayed

•Make sure the correct Input is selected.

•Make sure the desired video source is on and its output is configured cor- rectly.

•Check cable connection from the desired video source to the projector.

Remote control does not work

•When using the remote, point it directly at the front of the projector.

•Remove any obstacles between the remote and the infrared sensor in the front of the projector.

•Make sure the remote control batteries are in good condition and are inserted correctly.

3D content cannot be displayed

•Turn the projector off and the 3D source off.

•Ensure your source is 3D compatible and the 3D output is enabled. Ensure 1080p resolution and 24 Hz options are enabled in the 3D source to enjoy full HD 3D viewing. (See your 3D source user guide).

•Turn the projector on first and then turn the 3D source on. Try to play 3D con- tent again.

•Ensure your glasses are switched on and set to SIM2 3D mode.

5 Troubleshooting

Lumis 3D-S

35

 

User Guide

 

 

 

 

Page 34 Page 36
Image 35
Page 34 Page 36
Contents User Guide Contents Important information SafetyPlace the projector on a stable surface Power savingBe careful with cables Avoid contact with liquids and exposure to dampEnvironment 3D contentProduct disposal System Components Key Features and BenefitsIntroduction Optional Accessories Custom Remotes Remote ControlOverview Batteries Projector KeypadOperation Inputs Connections3D Glasses 3D IR EmitterMounting InstallationLocation Vertical Lens Shift Ceiling MountingOrientation Video KeystoneZoom and Focus Control 3D Glasses AC PowerTriggers IR EmitterSwitching Off Switching On and OffSwitching On Operation Viewing 3D ContentTo watch 3D Content via Blu-ray 3D Menu To Watch 3D Content via Satellite, Cable and Games Console3D Mode Supported 3D Video Formats 3D Input Format3D Left/Right DVB Input MenuMain Menu Contrast PictureBrightness Tint Sharpness ModeCinema Mode ColorAspect ImageDynamicBlack PureMotionColor Management Position Frequency/PhaseGamma Correction OverscanSetup Language Initial SettingsMenu Test PatternsOSD Background F1-F2 KeysSource Information Help MenuMemories OSD Display TimeoutSave Current Settings Rename Save Initial SettingsRecall Messages InfoQuick Menus Troubleshooting 3D image lacks depth 3D content is displayed as two near-identical imagesHdmi Connection Issues Specifications Uxga 781 169 Screen Projection DistancesDimensions Page SIM2 USA
Top Page Image Contents