AMD LE-366 user manual Cmos Setup

Page 16

LE-366 User’s Manual

2.5 <CMOS Setup>

The board’s data of CMOS can be setting in BIOS. If the board refuses to boot due to inappropriate CMOS settings, here is how to proceed to clear (reset) the CMOS to its default values.

Jumper: J4

Type: Onboard 3-pin jumper

J4 Mode

1-2		Normal Operation
2-3		Clear CMOS

Default setting

Jumper: J7

Type: Onboard 3-pin jumper

J7 Mode

1-2		Master
2-3		Slave

Default setting

3 1

-15-

Image 16

Contents

LE-366 Disclaimer CopyrightTrademark Packing List HardwareCable Kit Printed MattersIndex Appendix a I/O Port Pin AssignmentPage Is Left For Blank Introduction Product OverviewProduct Specification General SpecificationExpansive Interface Mechanical Drawing Block Diagram Hardware Setup 1Connector LocationJP2 JP3 Jumper ReferenceConnector Reference External ConnectorCPU Setup CPU and Memory SetupMemory Setup Cmos Setup Enhanced IDE & CF Interface Floppy Port FDDOnboard Display Interface Analog VGA InterfaceDigital Display Pin DescriptionPin Assignment LCD Installation Guide Preparing the LE-366,LCD panel and the backlight inverterPanel Number Resolution USB2.0 Interface Gpio Interface Serial Port Jumper Setting Power Input Power and Fan ConnectorPower Output Fan Connector Indicator and Switch This Page is Left For Blank Bios Setup 1CMOS Setup Utility Main ScreenThis Page is Left for Blank Appendix a I/O Port Pin Assignment IDE PortSerial Port LAN Port CRT PortUSB Port PS/2 Keyboard & Mouse Port This Page is Left for Blank Bios Auto Flash Tool Appendix B Flash BiosFlash Method Appendix C System Resources C1. I/O Port Address MapLE-366 User’s Manual C2. Memory Address Map C3. System IRQ Resources Appendix D Programming GPIO’s GPIO0...GPIO7Appendix E Watch Dog timer Setting Program SampleThis Page is Left for Blank