AMX specifications Installation Sheet, RDM-SWMSwitch Module 2400 W

Page 1

Installation Sheet

RDM-SWMSwitch Module 2400 W

The RDM-SWM Switch Module is a 2400 W general purpose relay module built for economical switching of incandescent lamps, low-voltage transformers, switched fans and electrical outlets. It is designed for use with the RDA series of enclosures, in an AMX Lighting™ modular digital dimming system. The RDM-SWM uses a positive air gap type relay. This module's 120, 240, and 277 VAC ratings are CE, UL, and C-UL approved.

Specifications

• Dimensions (HW): 10.00" x 2.75" (25.40 cm x 6.99 cm)

Non-phase dependant

• Use wires rated at 75°C (167°F)

• Torque terminals to 7 in-lbs. (0.8 N/M)

• Max. wire size: 10 AWG (4 mm²)

• Wire stripping length: 0.28" (7 mm)

Mounting points

Line in (hot)

Load out

High-voltage connections

• Weight: 0.5 lbs. (0.227 kg)

BTU/hr: 5

Control current: 85 mA @ 12 VDC

Caution: Pre-Installation Notes

• All Class 1 wiring must be connected to proper terminals.

• All control wiring must be connected to proper terminals.

• Disconnect power while installing or connecting the unit.

• Keep top and bottom air vents clear at all times.

• Test loads for shorts before connecting.

• Use low-voltage wires with a 300 volt rating or greater.

• Use field installed copper conductors.

Relay A

Low-voltage control wiring: 4-pin connector to AMX Lighting master controller

• All electrical ratings are for continuous duty.

For indoor use only.

This module may require extra power from the AXlink connection or an

 

external power supply connected to the control card.

Connecting the RDM-SWM to the AMX Lighting Master

Pin 4 (GND)

Pin 3 (RLY)

Pin 2 (DIM)

Pin 1 (+12 V)

RDM-SWM 4-pin module connector

3(-)

1 (+)

4-pin plug from RDM series module

NOTE: The 4-pin plugs from the module connector to

the 4-pin connector on the master (black plug cover facing up).

FIG. 1 RDM-SWM Switch Module

FIG. 2 RDM-SWM connections

RDM-SWM UL and C-UL Ratings

General purpose: 2400 W

Resistive: 2400 W

Ballast: 2400 W

Motor: 277 VAC, 1 hp

Suggested Switched Loads

Incandescent

Low-voltage

Motors

Switched outlets

Fluorescent

Image 1
Contents RDM-SWMSwitch Module 2400 W Installation SheetLighting Application Drawings RDM-SWM Switch Module 2400 line wiring configuration