External 3.5 Drive Installation, Snake Light

noise-dampening ability of the rubber grommets. Always mount the HDD with the thicker side of the silicone grommets facing up.

5.Repeat the same procedure for other devices as necessary.

6.Connect 4-pin molex or SATA power connectors on the power supply to the power connectors on each of the devices.

7.Slide the cage back to the case and fasten the thumbscrew.

External 3.5” Drive Installation

There is one external 3.5” drive bay.

1.Carefully remove the plastic drive bay cover and metal plate covering the drive bay.

2.Find a pair of 3.5”drive rails from the box containing the top fan spoiler.

3.Mount the drive rails onto the sides of the 3.5” device. Make sure the metal portion is angled on the outside and facing forward.

4.Slide the device into the drive bay until it clicks into position.

5.Connect a small 4-pin connector from the power supply to the 4-pin connector on the floppy drive.

5.25” Device Installation

There are four 5.25” drive bays that require a total of eight drive rails.

1.Carefully remove the plastic drive bay cover and the metal plate covering the drive bay.

2.Mount the drive rails onto the sides of the 5.25” device. Make sure the metal portion is angled on the outside and facing forward.

3.Slide the device into the drive bay until it clicks into position.

4.Mount other devices accordingly.

5.Connect 4-pin molex connectors from the power supply to the 4-pin connector on each of the devices.

PCI-Express Add-in Card Holder

There are two PCI-E card holders for the newest dual graphic card systems in the tool bag. An instruction sheet on how to install them is included as well.

The Snake Light

A white LED snake light is included to illuminate the inside of your case and features a flexible neck that can be adjusted to any desired position. To turn it on, simply connect it to a molex connector or the internal USB connector while the system is in standby mode (i.e., the computer is off but with the power supplies are plugged in to the AC outlet).

Note: The Snake Light comes with both the 4-pin molex or the internal USB connectors. Please do not connect the light to both connectors the same time.

Cooling System

The TriCool™ fan:

The case includes four installed 120mm TriCool™ fans. The three-speed fans let you choose between quiet performance or maximum cooling (see specifications below). Note: The minimum voltage to start the fan is 5V. We recommend our users to set the fan speed to High if you choose to connect the fan to a fan control device. A fan-controller regulates the fan speed by varying the voltage to it. The voltage may start as low as 4.5V to 5V. Connecting a TriCool™ set on Medium