2.3CABLE MANAGEMENT
There is a cable management compartment behind the 3.5” drive cage.
You can tuck or route excess cables in this compartment.
1.Open the right side panel as described in section 2.1.
2.Locate the cable management compartment with cable ties located behind the walls of the 3.5” drive cage.
3.Tuck or route your excess cables to the compartment. This will keep the cables from interfering with airflow in your case and help with cooling.
4.Use the cable ties provided to hold them in place.
2.4MOTHERBOARD INSTALLATION
1.Lay the case down, with the open side facing up. The drive cages and power supply should be visible.
2.Make sure you have the correct I/O panel for your motherboard. If the panel provided with the case isn’t suitable, please contact your motherboard manufacturer for the correct I/O panel.
3.Align your motherboard with the standoff holes and remember which holes are lined up. Not all motherboards will match with all the provided holes; this is normal and won’t affect its functionality.
4.Remove your motherboard by lifting it up.
5.Install standoffs as needed and put the motherboard back in.
6.Screw in your motherboard to the standoffs with the provided
Note: The Two Hundred comes with a CPU cutout on the motherboard tray, which will allow you to change your CPU heatsink without removing the motherboard.
5