2.5INTERNAL 3.5” DEVICE INSTALLATION
The Two Hundred provides space for up to six 3.5” hard drives. Before you begin, remove the side panels and front bezel of the case as described in section 2.1. Behind the front bezel there is a fan cage which provides space for up to two fans at the front of the case.
1.Open the fan cage by pressing both clips to release it, then swing it open and detach it from the chassis.
2.Insert your 3.5” device into the 3.5” drive cage from the front of the case until the mounting holes align with the screw holes in the cage.
3.Fasten the device in place with the provided screws.
4.Mount any other 3.5” HDD devices accordingly.
5.Connect the appropriate power and data cables to the device(s).
6.Replace the fan cage.
2.6
This case comes with a
Note: Before you can use the hot swap feature, you must install all related drivers that come with your motherboard and turn on the “AHCI” function in the BIOS to activate the hot swap feature.
Loading:
1.Align your SATA HDD with the drive bay with the connector facing the case.
2.Push the HDD all the way into the bay until it locks into position.
Unloading:
1.Ensure that your HDD is not in use.
2.Push the release button on the
6