Installation Guidelines

Follow these guidelines when installing the TVS:

•When connecting the TVS to an INPUT/OUTPUT port on an AMX device, the Yellow (signal) wire is connected to the I/O pin on the INPUT/OUTPUT port.

•Do not over-torque screws on the connector. Doing so can damage the seating pin and damage the connector.

•If your application includes multiple CRT's in close proximity, use MED or LOW sensitivity settings to minimize potential interference.

•Mount the TVS close to the picture tube yoke. In most cases, the pic- ture tube yoke is located in the rear center of the CRT cabinet. Be sure to place the TVS in a position where the green LED signal indi- cator is visible during installation.