AMX dimensions Installing the TVS

Installing the TVS

To install the TVS:

1.Connect the TVS to the AMX device's INPUT/OUTPUT connector, fol- lowing the wiring configuration chart (see Wiring the TVS).

2.Turn on the CRT.

3.Set the SENSITIVITY switch on the TVS to MED.

4.Position the TVS on the CRT cabinet so it is as close to the picture tube yoke as possible. The green LED signal indicator must be visible during the installation process.

5.If the green LED signal indicator does not light, move the TVS closer to the picture tube yoke, or set the SENSITIVITY switch to HIGH, or do both.To accommodate the electromagnetic field produced by large CRT's, you may have to move the TVS away from the picture tube yoke and/or reduce the sensitivity setting.

6.When the green LED signal indicator lights, fasten the TVS to the CRT cabinet with the supplied Velcro™ strips.