D-Link DKVM-2/4 user manual

Page 7

Step 3. Connect your PS/2 keyboard and PS/2 mouse to the front panel of the DKVM-2/4. The connections should be made to the two 6-pin Mini DIN connectors labeled =CONSOLE= as shown below.

Step 4. Now the PC connections will be made with the monitor (VGA) connections. Connect a VGA cable (15-pin HDDB Male / Male) with the Male side to both the PC and to the connector labeled VGA on the rear panel of the DKVM-2/4 unit. Repeat this for all PCs.

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents User’s Manual DKVM-2/4Contents Introduction Package Contents Product FeaturesFront Panel Layout Rear Panel Layout Hardware InstallationPage Page Page Page Page Using the DKVM-2/4 Keyboard HOT KEY Commands Optional Cable Troubleshooting Mouse Image on my monitor is not clear. What can be the cause? Page Operation and Storage parameters SpecificationsOffices Limited Warranty What You Must Do For Warranty Service What Is Not Covered Page Trademarks CE Mark Warning Registration Card
Top Page Image Contents