D-Link Comprehensive Guide to Installing Your Unmanaged Gigabit Ethernet Switch

D-Link DGS-1008D Unmanaged Gigabit Ethernet Switch

Mounting the Switch on a Wall

The DGS-1008D can also be mounted on a wall. Two mounting slots are provided on the bottom of the switch for this purpose. Please make sure that the front panel is exposed in order to view the LEDs. Please refer to the illustration below:

A.) Mounting on a cement wall

1.Mount the Nylon screw anchors into a cement wall.

2.Drive the T3 x 15L screws into the Nylon screw anchors.

3.Hook the mounting holes of the switch back on the screws; you have completed the wall-mount.

B.) Mounting on a wood wall

1.Drive the T3 x 15 L screws into the wood wall.

2.Hook the mounting holes of the switch back on the screws; you have completed the wall-mount.

(1) 3/4 inch minimum for wood wall

(2) 3 inch minimum for cement wall.

Figure 2-1. Mounting the Switch to a Wall

Attaching the Rubber Feet

Use rubber feet provided. Position and apply rubber feet to the underside of the DGS-1008D Switch.

Figure 2-2. Attaching the Rubber Feet

7