D-Link DGS-1008D Unmanaged Gigabit Ethernet Switch
IP address Internet Protocol address. A unique identifier for a device attached to a network using TCP/IP. The address is written as four octets separated with
IPX Internetwork Packet Exchange. A protocol allowing communication in a NetWare network.
LAN Local Area Network. A network of connected computing resources (such as PCs, printers, servers) covering a relatively small geographic area (usually not larger than a floor or building). Characterized by high data rates and low error rates.
latency The delay between the time a device receives a packet and the time the packet is forwarded out of the destination port.
line speed See baud rate.
main port The port in a resilient link that carries data traffic in normal operating conditions.
MDI Medium Dependent Interface. An Ethernet port connection where the transmitter of one device is connected to the receiver of another device.
MIB Management Information Base. Stores a device’s management characteristics and parameters. MIBs are used by the Simple Network Management Protocol (SNMP) to contain attributes of their managed systems. The Switch contains its own internal MIB.
multicast Single packets copied to a specific subset of network addresses. These addresses are specified in the
protocol A set of rules for communication between devices on a network. The rules dictate format, timing, sequencing and error control.
resilient link A pair of ports that can be configured so that one will take over data transmission should the other fail. See also main port and standby port.
RMON Remote Monitoring. Subset of SNMP MIB II which allows monitoring and management capabilities by addressing up to ten different groups of information.
RPS Redundant Power System. A device that provides a backup source of power when connected to the Switch.
server farm A cluster of servers in a centralized location serving a large user population.
SLIP Serial Line Internet Protocol. A protocol which allows IP to run over a serial line connection.
SNMP Simple Network Management Protocol. A protocol originally designed to be used in managing TCP/IP internets. SNMP is presently implemented on a wide range of computers and networking equipment and may be used to manage many aspects of network and end station operation.
Spanning Tree Protocol (STP) A
stack A group of network devices that are integrated to form a single logical device.
standby port The port in a resilient link that will take over data transmission if the main port in the link fails.
switch A device which filters, forwards and floods packets based on the packet’s destination address. The switch learns the addresses associated with each switch port and builds tables based on this information to be used for the switching decision.
TCP/IP A layered set of communications protocols providing Telnet terminal emulation, FTP file transfer, and other services for communication among a wide range of computer equipment.
Telnet A TCP/IP application protocol that provides virtual terminal service, letting a user log in to another computer system and access a host as if the user were connected directly to the host.
TFTP Trivial File Transfer Protocol. Allows you to transfer files (such as software upgrades) from a remote device using your switch’s local management capabilities.
UDP User Datagram Protocol. An Internet standard protocol that allows an application program on one device to send a datagram to an application program on another device.
VLAN Virtual LAN. A group of location- and
13