D-Link DES-1008D manual Identifying External Components, LED Indicators

Page 15

IDENTIFYING EXTERNAL COMPONENTS

This section identifies all the major external components of the DES-1008D. Both the front and rear panels are shown followed by a description of each panel feature. The indicator panel is described in detail in the next chapter.

Front Panel

The figure below shows the front panel of the DES-1008D.

?LED Indicator Panel

Refer to the LED Indicator section for detailed information about each of the DES-1008D’s LED indicators.

LED Indicators

Power Indicator (PWR)

This indicator lights green when the hub is receiving power, otherwise, it is off.

Loop Detect (LOOP)

When this indicator lights amber, it means that there is a loop detected, then the network needs to be re-configuration.

Image 15

Contents Recyclable Limited Warranty Iii What Is Not Covered Disclaimer of Other Warranties Except for the Limited Page FCC Warning Table of C Ontents About this GU I D E PurposeOverview of this User’s Guide Switching Technology T R O D U C T I O NFast Ethernet Technology Page Features Page Unpacking SetupIdentifying External Components LED IndicatorsRear Panel Page Connecting the DES-1008D PC to DES-1008DHub to DES-1008D Hub without Uplink MDI-II port DES-1008D to switch other devicesPort Speed & Duplex Mode RJ-45 Connector pin assignment RJ-45 P in SpecificationStandard RJ-45 receptacle/connector General Technical SpecificationsPerformance Physical and Environmental