Altinex MX2426CV manual Application Diagram Installation, Operation, Front Panel Control

Page 7

SWITCHERS

 

 

 

 

 

 

 

APPLICATION DIAGRAM

5

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

INSTALLATION

6

Step 1. Make sure that the power input is set to the proper AC voltage for your country. An incorrect setting can result in unit damage not covered by warranty.

Step 2. Connect the power cord to the unit and plug it into the power outlet.

Step 3. Connect the cables from the video sources (computers) to the input channels, local monitors to the loop outputs and connect the output channels to the display devices (monitors or projectors. A Shielded, high, quality coaxial cable is recommended for video cable runs.

Step 4. Verify that the display and audio equipment operates properly and results in perfect images and sound.

CONGRATULATIONS! YOU ARE DONE.

If you experience any problems, please call

1-800-258-4623 or 1-714-990-2300 for

international calls.

OPERATION

7

7.1 FRONT PANEL CONTROL

The front panel of the MX2426CV offers controls that are specifically designed for a courtroom environment. The SOURCE SELECT buttons allow a user to select between the presentation systems of the plaintiff or the defendant. The DISPLAY SELECT section of the switcher allows a user to turn ON or OFF, display devices connected to the respective ports. The RECALL/SAVE section of the control panel allows a user to store various presets in memory and recall them at the push of a button. To save a preset select the outputs to be controlled by one button and store the preset in any one of four memories by holding the memory button for 2 seconds. To recall just press the memory button.

7.2 MASTER DISABLE CONTROL

The MX2426CV is also equipped with a master disable control that allows disabling of the unit. This port is used to connect the Judge Override button. See the description below. The connection is accomplished by connecting one wire to the OFF pin and the other to the GND pin. When the OFF pin is shorted to ground, all video signals are terminated. INPUT SELECT SECTION

6

Image 7
Contents MX2426CV Introduction Table of ContentsPrecautions / Safety Warnings Technical Specification About Your MX2426CV SwitcherFrequency Compatibility MX2426CV DescriptionDisplay Outputs PowerINPUTS/OUTPUTS Computer InputsFront Panel Control Application Diagram InstallationMaster Disable Control OperationMX2426CV Contact RS-232 ControlRS-232 Protocol MX2426CV Frequently Asked QuestionsTroubleshooting Guide Cables and AccessoriesContact Information Sales Department Limited WarrantyAltinex Policy Return Policy