4.Position the switch onto the wall screws with the LEDs either facing up or down.
Warning
The power cord is used as a disconnection device. To
5
5.Plug the power adapter into a power source and then plug the DC power cord into the DC connector on the front panel of the switch.
6.Make sure the PWR LED on the front panel is green. If the LED is OFF, refer to “Troubleshooting” on page 31.
7.Connect the twisted pair cables to the twisted pair ports on the switch and on the end- nodes.
8.Power ON the
9.Check that the LNK/ACT LED for each port on the switch is green. If a LED is OFF, refer to “Troubleshooting” on page 31.
The
30