Z8F04A08100KIT Development Kit
User Manual
11
Table 1. Z8F04A08100KIT Jumper Functions
Jumper | State | Description | Default |
|
|
|
|
J7 | OUT | DEMO mode setting | X |
| IN | Chip U5 resets when SW1 pressed |
|
J8 | Connects U5 pin PA3 to J11 pin 1 | X | |
|
| (CTS0 EN) |
|
|
|
|
|
| Connects U5 pin PA3 to JP2 pin 35 |
| |
|
|
|
|
J9 | Connects U5 pin PA4 to RXD | X | |
|
| RS232 signal |
|
| Connects U5 pin PA4 to JP2 pin 35 |
| |
J10 | Connects U5 pin PA5 to TXD | X | |
|
| RS232 signal |
|
| Connects U5 pin PA5 to JP2 pin 36 |
| |
|
|
|
|
J11 | OUT | Disconnects PA3 from CTS0 | X |
|
| RS232 signal |
|
| IN | Connects PA3 to CTS0 RS232 |
|
|
| signal |
|
Note: * These jumpers must not be OUT at the same time
The board has two modes of operation: DEMO and USER. Use DEMO mode to run the sample program included with the kit. Run the board in USER mode:
•
•
When using the ZDI port to debug your code.
When configuring the board to run your own prototype code.
DEMO Mode Jumper Settings
When running the board in DEMO mode, the following jumpers MUST be set:
Development Board |