ADC Z8F04A08100KIT user manual Switches S1, S2, and SW1, External Interface Headers JP1 and JP2

Page 18

12

Z8F04A08100KIT Development Kit User Manual

J3 1-2

J4 OUT

J5 1-2

J6 1-2

J7 OUT

J8 1-2

J9 1-2

J10 1-2

J11 OUT

USER DEBUG Mode Jumper Settings

When running the board in USER DEBUG mode, the following jumpers MUST be set:

J3 OUT

J4 IN

J6 OUT

J7 IN

Switches S1, S2, and SW1

Switches S1, S2, and SW1 on the Z8 Encore! XP™ 4K Series 8-Pin Development board perform the following functions:

•

•

•

S1 – Test switch

S2 – Power ON/OFF switch SW1 – RESET

External Interface Headers JP1 and JP2

External interface headers JP1 and JP2 are shown in the schematic on page 15.

Development Board

UM018702-0505

Image 18

Contents UM018702-0505 Z8F04A08100KIT Development Kit Table of Contents Table of Contents UM018702-0505 List of Figures Z8 Encore! XP 4K Series 8-Pin Development BoardList of Figures UM018702-0505 Kit Contents IntroductionSoftware on CD-ROM Supported Host System Configuration System/Software RequirementsDocumentation Designing with the USB Smart Cable Installation Installation UM018702-0505 Development Board IntroductionFeatures MCUUart with IrDA Endec Jumpers and Settings Provides information on jumper functionsDemo Mode Jumper Settings CTS0 ENSwitches S1, S2, and SW1 User Debug Mode Jumper SettingsExternal Interface Headers JP1 and JP2 Use of Ceramic Resonator Y1 Development Board UM018702-0505 Schematic UM018702-0505 Schematic Z8F04A08100KIT Connector JP1