2.2 DIP-Switch
The DIP-Switch is used to configure operation mode for LFP (Link Fault Pass- Through) and operation mode for UTP/Fiber port. The default value of DIP-switch is OFF.
Table 2.2: EKI-2741series DIP-Switch Definition
| S/W No | Status | Description |
| 1 | ON | Enables Port/Power Alarm |
| | |
| OFF | Disable Port/Power Alarm |
| |
| | | |
| 2 | ON | Enables LFP |
| | |
| OFF | Disables LFP |
| |
| | | |
Link Fault Pass-Through(DIP-Switch 2): When LFP is enabled, it allows UTP link failures to be reported to the fiber side and also allows Fiber link failures to be reported to the UTP side. Therefore, a link loss forwarding feature is provided in both UTP and Fiber side.
Note | Please don’t change the DIP-switch setting when UTP or fiber port is |
| transmitting or receiving data. It may cause some data error. Besides, if you |
| change the DIP-switch setting, please power off the converter and power on |
| again to make the setting effective. |
