Safety Instructions

Strictly follow these instructions for use and please read them carefully. Keep this User's Manual for later reference. Any use of the product requires full understanding and strict observation of all portions of these instructions. Observe all WARNINGS and CAUTIONS as rendered throughout this manual and on labels on the equipment.

Repair of the device may only be carried out by trained service personnel. It is rec- ommended that a service contract be obtained with Advantech and also that all repairs be carried out by them. Failure to do so may result in the incorrect functioning of the device.

Warning! Due to the danger of electric shock, never remove the cover of a device while it is in operation or connected to a power outlet.

If one of the following situations arises, have the equipment checked by service per- sonnel:

a.The power cord or plug is damaged.

b.Liquid has penetrated the equipment.

c.The equipment has been exposed to moisture.

d.The equipment does not work well, or you cannot get it to work according to the user's manual.

e.The equipment has been dropped and damaged.

f.The equipment has obvious signs of breakage.

Disconnect this equipment from any AC outlet before cleaning. Use a damp cloth. Do not use liquid or spray detergents for cleaning and keep this equipment away from humidity.

Caution! To avoid short-circuits and otherwise damaging the device, do not allow fluids to come in contact with the device. If fluids are accidentally spilled on the equipment, remove the affected unit from service as soon as pos- sible and contact service personnel to verify that patient safety is not compromised.

Put this equipment on a reliable surface during installation. Dropping it or letting it fall may cause damage. For plug-in equipment, the power outlet socket must be located near the equipment and must be easily accessible.

Caution! To prevent overheating, it is recommended to install the unit in an upright position. Do not lie it flat on a table and do not cover the open- ings or place the device in direct sunlight or near radiant heaters.

Make sure the voltage of the power source is correct before connecting the equip- ment to the power outlet. Position the power cord so that people cannot step on it. Do not place anything over the power cord. If the equipment is not used for a long time, disconnect it from the power source to avoid damage by transient over voltage.

iii	POC-S196 User Manual