Introduction
This guide is designed to enable quick installation of the ADIC FastStor 1 autoloader. For additional product and operation details, please refer to the ADIC FastStor 1 Installation and User Manual.
The following steps summarize FastStor 1 installation:
•Unpack the FastStor 1
•Install the FastStor 1 in a rack
•Connect the power cable to the FastStor 1
•Turn on the FastStor 1
•Remove the transport lock by following the instructions displayed on the front panel
•Select the appropriate SCSI IDs and unit options
•Connect the SCSI interface cable, and optionally the Ethernet cable
•Install the backup application software and configure it for use with the FastStor 1
•Load cartridges into the removable magazines
In order to complete full installation of the FastStor 1, the following additional materials are required:
•Simple hand tools (small Phillips screwdriver)
•SCSI Host adapter card with
•Tape application software that is verified with the FastStor 1
•Up to 8 pieces of the appropriate cartridge type to “stock” the FastStor 1 to full capacity.
FastStor 1 Quick Installation Guide | 1 |