FastStor 1 Quick Installation Guide

Attention: The FastStor 1 is designed to operate in a horizontal position. Do not attempt to operate the FastStor 1 in any position other than horizontally. Also make sure that:

•The airflow around the front and back of the FastStor 1 is not obstructed.

•There is a minimum of 60cm free space in front of the unit to allow the operator to safely remove the magazines.

•The display and operator controls are easily accessed.

•The FastStor 1 is situated away from the floor and in a clean environment with temperatures within specifications.

The Rack Mounting Kit includes the following items:

•Rail Left Assembly

•Rail Right Assembly

•Screw M6x12 (4 pieces)

•Screw M5x8 (2 pieces)

•Screw M4x12 (4 pieces)

•Nut M4 Hex (4 pieces)

•Washer to M6 (4 pieces)

•Washer to M4 (4 pieces)

Recommended mounting tools:

•Folding rule or tape measure

•Phillips #2 screwdriver

•7 mm open-end wrench

Note: The rails are mounted to the loader during transportation. Before mounting the rails into the rack, dismount the rails from the loader and remove the spacers between the rails and the loader.