Accton Technology ES4524M-POE manual SFP Slots, Port and System Status LEDs

Description of Hardware 1

Each of these ports support auto-negotiation, so the optimum transmission mode (half or full duplex), and data rate (10, 100, or 1000 Mbps) can be selected automatically†.

SFP Slots

The Small Form Factor Pluggable (SFP) transceiver slots are shared with two of the RJ-45 ports (ports 23-24). In its default configuration, if an SFP transceiver (purchased separately) is installed in a slot and has a valid link on its port, the associated RJ-45 port is disabled and cannot be used. The switch can also be configured to force the use of an RJ-45 port or SFP slot, as required.

Port and System Status LEDs

The switch includes a display panel for key system and port indications that simplify installation and network troubleshooting. The LEDs, which are located on the front panel for easy viewing, are shown below and described in the following tables.

RJ-45 Port Status LEDs

Power LED

Figure 1-3 Port and System LEDs

Table 1-1 Port Status LEDs

LED	Condition	Status
1-24	On/Flashing Amber	Port has a valid link at 10 or 100 Mbps. Flashing
(Link/Activity/		indicates activity.
Speed)
	On/Flashing Green	Port has a valid link at 1000 Mbps. Flashing indicates
		activity.
	Off	There is no link on the port.
PoE	Amber	A PoE device is connected.
	Amber Blinking	A PoE device is connected and data is being
		transmitted.
	Off	No PoE device connected.

†The 1000BASE-T standard does not support forced mode. Auto-negotiation must always be used to establish a connection over any 1000BASE-T port or trunk.

1-3