Paxar 7400 manual E r a t i n g R F l i n k, Rascal Printers

Page 11

Rascal Printers

To link a Rascal printer to a data collection terminal:

1.Turn the printer, terminal, and the RF link modules off.

2.Turn on the printer.

3.Turn on the printer's RF link module. The green LED turns on.

4.Turn on the terminal's RF link module. The green LED turns on. Then the LEDs on both modules start blinking.

5.Turn on the terminal.

O p e r a t i n g R F l i n k

To operate RF link:

1.Initialize the printer/terminal connection (see "Linking RF link" for more information).

2.Use the printer and the terminal as you normally would.

NOTE: You can walk out of the 3-meter range and scan up to 4 items. When you walk back into the 3-meter range, the printer prints those labels.

There are no software configurations or commands to change the operating parameters.

RF link Operating Instructions 11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents P a c k i n g R F l i n k L I N K O P E R a T I N G S T R U C T I O N SD u l e / U n i t D i a g r a m s LDT/LRT 3800 and PDT Install i n g R F l i n k M o d u l e sPDT RF link Operating Instructions Printer PrintersInserting Batteries N k i n g R F l i n k U n i t sSierra Sport 2 Printers Renegade 4 Printers with Internal Modules Renegade 4 Printers with External Modules Rascal Printers E r a t i n g R F l i n kM o v i n g R F l i n k M o d u l e s Battery LifePrinter Power Source W e r i n g R F l i n kTroubleshooting Returning RF link to Monarch Page Canadian D.O.C. Warning
Top Page Image Contents