Paxar 9414 manual 6Getting Started

Page 10

14. Plug the printer’s power supply cable (with the straight end) into the socket on the back of the printer.

Power Cable

Serial Cable

15. Connect the serial cable to the printer’s serial port.

16. If necessary, adjust the cables. Make sure all the cables move freely through the openings in the back of the tray. Use a cable tie to secure them.

17. Lift up the keypad/terminal with one hand and feed the scanner cable connector through the notch as shown.

Scanner

Cable

1-6Getting Started

Image 10

Contents Monarch 9414 Printer Canadian D.O.C. Warning B L E O F C O N T E N T S Troubleshooting T T I N G S TA R T E D P a c k i n g t h e M R D S y s t e mT t i n g U p t h e S y s t e m To keypad/terminal To printer 4Getting Started Shaped Connector Serial Cable 6Getting Started Getting Started Indicator light monitors the printers status A d i n g t h e I n d i c a t o r L i g h tE a r i n g t h e B u f f e r I t c h i n g P r i n t M o d e s10Getting Started I N G T H E P I Z Z a T t i n g t h e D a t e / T i m e / H o t H o l d T i m e Using the Pizza Hut Application L e c t i n g a L a n g u a g e A d i n g L a b e l s Loading Labels for MRD and Dough Staging6Using the Pizza Hut Application Using the Pizza Hut Application 8Using the Pizza Hut Application Loading Labels for Hot Hold Items 10Using the Pizza Hut Application I n g t h e K e y p a d / T e r m i n a l B u t t o n s A d i n g t h e S c a n S h e e t O c e s s i n g t h e P r o d u c t Hot Hold Labeling Stage 2 Label Stage 3 Label From Frozen to Pre Top T u r e D o w n l o a d s 18Using the Pizza Hut Application R E a N D I N T E N a N C E E a r i n g L a b e l J a m sE a n i n g t h e P r i n t h e a d E c k i n g t h e S o f t w a r e V e r s i o nMake Sure the Power is OFF 4Care and Maintenance Troubleshooting Load labels for non-peel mode X a r B a r code P r o d u c t L i m i t e d W a r r a n t y 4Troubleshooting Page 6Troubleshooting