Paxar 9640 manual Loading the Ribbon

Page 7

Operators Handbook English

Paxar Monarch 9640 Series

(c) Loading the Ribbon

1.Lift the printer top cover and keep it in the open position.

2.Release the print head module and raise it to the vertical position.

3.Unwrap the ribbon roll.

4.Place the supply roll into the supply holder of the print head module with the notch on the left-hand side as shown in the diagram. The spindle is on a spring and will allow for easy fitting of the ribbon.

5.Fit the take up core into the spindle inserting the left-hand side first.

6.Release the leader end of the ribbon and attach it squarely to the upper spindle (this is the take-up core).

7.Take up any slack in the ribbon by rotating the white cog on the left-hand side of the printer.

8.Press the print head module down firmly until it snaps into place on both sides.

9.Close the top cover.

take-up holder

ribbon supply roll

supply holder

Note: This procedure is not necessary when direct thermal media is used.

9640 Series

5

English

Image 7
Contents 9640 Paxar Monarch 9640 Series General Introduction SeriesTop cover On/Off switchPower jack Parallel portConnecting the Printer to Your Host Connecting the Power CordClose the top cover How to load the printerLoading Label or Card Stock Loading StockLoading the Ribbon Printer Driver Installation Selecting the correct printer port Installation of Speedy Label SoftwareInstallation with CD ROM Installation with disketteLED Indication Conditions TroubleshootingPlaten Roller MaintenanceThermal Print Head Replacement Thermal Print HeadPower Adapter Specification Printer Specifications