Appendix C: Setting up the Power Supply
Installation Instructions:
1.Plug the power cable into the Network Jack.
2.Route the power cable through the stain relief fixture.
3.Secure the local power supply and cable to the wall.
4.Plug the Local Power Supply into the power source.
NOTE: Completing these procedures in sequence will reduce issues during the installation process.
The NJ90 works with the following Power Supplies. Updated infor- mation is available online at www.3com.com/products
|
|
|
Component | Purpose | 3C Number(s) |
Integrated Switch | For providing Power over | 3C17205 |
with Power over | Ethernet to power up to |
|
Ethernet | 24 NJ90's |
|
For providing Power Over | 3CNJPSE24 | |
power supply | Ethernet to power up to |
|
(Uses Spare Pairs) | 24 NJ90s. |
|
For providing Power over | 3CNJPSE | |
power supply | Ethernet to power a single |
|
(Uses Spare Pairs) | NJ90. |
|
Local power supply | For locally powering a | 3CNJPSL |
| single NJ90; required if |
|
| your network does not |
|
| support Power Over |
|
| Ethernet. |
|
11