MANAGING THE MODULE
When the Module is installed you can configure it through your Switch. Refer to the SuperStack® 3 Switch Implementation Guide and the Management Interface Reference Guide supplied with your Switch for more information.
MODULE RESTRICTIONS
When using the Module, note the following:
TThe ports only operate at 1000 Mbps.
The ports only operate in full duplex mode.
The Module is not
The Module is not
The Module only operates with multimode fiber optic cable.
PROBLEM SOLVING
If you suspect a problem, carry out these steps before contacting your supplier:
Ensure that the Module is correctly installed in the Switch and that the three captive thumbscrews which secure the Module are tightened with a suitable tool.
Ensure that the Switch in which the Module is fitted
Tis
Ensure that the device at the far end of the link is
Check that all connectors on the fiber optic segment
Tare correctly engaged.
Clean the terminators by wiping them gently with a clean tissue or cotton bud moistened with a little ethanol. Dirty fiber terminators on the fiber optic segment impair the quality of the light transmitted through the cable.
For information about technical support, refer to “Technical Support”on page 7.
4