6TRSM Installation
4Grasp the inject/eject handles of the module and push them outward as shown in Figure 2.
Module faceplate
Figure 2 Handles in Outward Position
5Remove the module from the system.
6Place the module in its antistatic bag.
Installing the TRSM The installation procedure takes only a few minutes to complete. You need a small,
NOTE: Only the LMM may be inserted in slot one of the LANplex system. The system will not operate if any other module is inserted into slot one. Slot one of the LANplex 6004 is the bottom slot, and slot one of the LANplex 6012 is the first slot on the left.
To install the TRSM in an empty slot in the LANplex system, perform the following steps:
1Discharge yourself of static electricity by placing the ESD wrist strap on your wrist and clipping the alligator clip to the mounting screw located next to the black ground symbol on the system’s right mounting bracket. See Figure 3. If your system does not have mounting brackets, touch the rear panel.