Rosewill RNX-N2LX user manual unable to connect to the wireless network and/or the Internet?

Page 32

Wireless N Adapter RNX-N2LX		User Manual

unable to connect to the wireless network and/or the Internet?

Check that the LED indicators for the broadband modem are indicating normal activity. If not, there may be a problem with the broadband connection.

Check that the LED indicators on the wireless router are functioning properly. If not, check that the AC power and Ethernet cables are firmly connected.

Check that the IP address, subnet mask, gateway, and DNS settings are correctly entered for the network.

In Infrastructure mode, make sure the same Service Set Identifier (SSID) is specified on the settings for the wireless clients and access points.

In Ad-Hoc mode, both wireless clients will need to have the same SSID. Please note that it might be necessary to set up one client to establish a BSS (Basic Service Set) and wait briefly before setting up other clients. This prevents several clients from trying to establish a BSS at the same time, which can result in multiple singular BSSs being established, rather than a single BSS with multiple clients associated to it.

Check that the Network Connection for the wireless client is configured properly. If Security is enabled, make sure that the correct encryption keys are entered on both the Adapter and the access point.

Thank you for purchasing a quality Rosewill Product.

Please register your product at: www.rosewill.com for complete warranty information and future support for your

product.

32

Image 32

Contents Wireless N Adapter RNX-N2LX FCC STATEMENT FCC RF Radiation Exposure StatementCE Mark Warning National RestrictionsWireless N Adapter RNX-N2LX Table of Content 1.2 Overview of the Product 1.1 Package ContentChapter 1 Overview 1.3 Features 1.4 SpecificationStorage Humidity 1.5 System RequirementDriver support Chapter 2 Installation Guide 2.1 Software Installation Click Install to start installing  Click Next Follow the InstallShield Wizard steps, and click Finish when done  Now your PC or notebook will restart automaticallyInstall USB adapter Chapter 3 Install Wireless Adapter3.1 USB adapter Installation Wireless N Adapter RNX-N2LX Chapter 4 Configuration - Station Mode 4.1 GeneralGeneral Information 11n USB Wireless LAN UtilityOthers 4.2 ProfileNetwork Address  Create a new ad-hoc mode profile 4.2.1 Add Create a new Infrastructure mode profile 4.2.2 Remove created a profile4.2.3 Edit Select a profile and click Edit button to edit this profile FigureImport the new profile name in the popup window blank Figure 4.2.4 DuplicateModify the profile information according to your demand 4.2.5 Set default 4.3 Available NetworkDouble-click the network to which you wish to connect 4.4 Status 4.5 Statistics4.6 Wi-Fi Protect Setup 4.6.1 Method 1 PIN Input Config PIN 2. Click Pin Input ConfigPIN4.6.2 Method 2 Push Button 1. Click Push Button ConfigPBC on Wi-Fi Protect Setup pageRemark Chapter 5 Access Point Mode - Soft AP mode 5.1 GeneralConfigure this AP. Click config, display the following picture 5.2 Advanced It display receive and transmit information 5.3 Statistics5.4 ICS Wireless N Adapter RNX-N2LX 1. The Wireless USB Adapter does not work properly 3. What should I do when the computer with the Adapter installed isunable to connect to the wireless network and/or the Internet?