Rosewill RNX-N2LX user manual The Wireless USB Adapter does not work properly

Page 31

Wireless N Adapter RNX-N2LX

User Manual

 

 

 

FAQ

This chapter provides solutions to problems that may occur during the installation and operation of the Wireless USB Adapter. Read the descriptions below to solve your problems.

1.The Wireless USB Adapter does not work properly.

Reinsert the Wireless USB Adapter into your PC’s USB slot. Right click My Computer and select Properties. Select the device manager and click on the Network Adapter. You will find the Adapter if it is installed successfully. If you see the yellow exclamation mark, the resources are conflicting. You will see the status of the Adapter. If there is a yellow question mark, please check the following:

Make sure that you have inserted the right adapter and installed the proper driver. If the Adapter does not function after attempting the above steps, remove the adapter and do the following:

Uninstall the driver software from your PC through Control Panel’s “Add or Remove Programs”.

Restart your PC and repeat the hardware and software installation as specified in this User Guide.

2.I cannot communicate with the other computers linked via Ethernet in the Infrastructure configuration.

Make sure that the PC to which the Adapter is associated is powered on.

Make sure that your Adapter is configured on the same channel and with the same security options as with the other computers in the Infrastructure configuration.

3.What should I do when the computer with the Adapter installed is

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Wireless N Adapter RNX-N2LX National Restrictions FCC STATEMENTFCC RF Radiation Exposure Statement CE Mark WarningWireless N Adapter RNX-N2LX Table of Content Chapter 1 Overview 1.1 Package Content1.2 Overview of the Product 1.4 Specification 1.3 FeaturesDriver support 1.5 System RequirementStorage Humidity 2.1 Software Installation Chapter 2 Installation Guide Click Next  Click Install to start installing Now your PC or notebook will restart automatically  Follow the InstallShield Wizard steps, and click Finish when done3.1 USB adapter Installation Chapter 3 Install Wireless AdapterInstall USB adapter Wireless N Adapter RNX-N2LX 11n USB Wireless LAN Utility Chapter 4 Configuration - Station Mode4.1 General General InformationNetwork Address 4.2 ProfileOthers  Create a new Infrastructure mode profile 4.2.1 Add Create a new ad-hoc mode profile created a profile 4.2.2 RemoveSelect a profile and click Edit button to edit this profile Figure 4.2.3 EditModify the profile information according to your demand 4.2.4 DuplicateImport the new profile name in the popup window blank Figure 4.3 Available Network 4.2.5 Set defaultDouble-click the network to which you wish to connect 4.5 Statistics 4.4 Status4.6 Wi-Fi Protect Setup 2. Click Pin Input ConfigPIN 4.6.1 Method 1 PIN Input Config PIN1. Click Push Button ConfigPBC on Wi-Fi Protect Setup page 4.6.2 Method 2 Push ButtonRemark 5.1 General Chapter 5 Access Point Mode - Soft AP modeConfigure this AP. Click config, display the following picture 5.2 Advanced 5.4 ICS 5.3 StatisticsIt display receive and transmit information Wireless N Adapter RNX-N2LX 3. What should I do when the computer with the Adapter installed is 1. The Wireless USB Adapter does not work properlyunable to connect to the wireless network and/or the Internet?
Top Page Image Contents