Chapter 4 Configuring Settings on the Cisco Unified IP Phones

Security Configuration Menu

Table 4-25describes the 802.1X Authentication Real-Time Status.

Table 4-25

802.1X Authentication Real-Time Status

 

 

 

 

 

Option

 

Description

To Change

 

 

 

802.1X Authentication

Real-time progress of the 802.1X authentication

Display only—Cannot configure.

Status

 

status, displaying one of the following states:

 

 

 

Disabled—802.1X is disabled and transaction

 

 

 

 

was not attempted

 

 

 

Disconnected—Physical link is down or

 

 

 

 

disconnected

 

 

 

Connecting—Trying to discover or acquire the

 

 

 

 

authenticator

 

 

 

Acquired—Authenticator acquired, awaiting

 

 

 

 

authentication to begin

 

 

 

Authenticating—Authentication in progress

 

 

 

Authenticated—Authentication successful or

 

 

 

 

implicit authentication due to timeouts

 

 

 

Held—Authentication failed, waiting before

 

 

 

 

next attempt (approximately 60 seconds)

 

 

 

 

 

 

VPN Configuration

The VPN Configuration menu allows you to enable a virtual private network (VPN) connection using the Secure Sockets Layer (SSL) when a phone is located outside a trusted network or when network traffic between the phone and Cisco Unified CM crosses untrusted networks.

Note VPN Client is supported only for the Cisco Unified IP Phones 7942G and 7962G.

You configure the VPN Client feature as needed. If it is enabled and the VPN Client mode is enabled on the phone, you are prompted for your credentials as follows:

If your phone is located outside the corporate network, you are prompted at login to enter your credentials based on the authentication method that you configure on your phone.

If your phone is located inside the corporate network,

Note

When the power is lost

If Auto Network Detection is disabled, you are prompted for credentials, and a VPN connection is possible.

If Auto Network Detection is enabled, you cannot connect through VPN so you are not prompted.

Connecting to VPN

Use this procedure to access the VPN Configuration settings and connect through VPN.

 

Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)

4-46

OL-23091-01

Page 118
Image 118
Cisco Systems 8.6 manual VPN Configuration, Connecting to VPN, 25describes the 802.1X Authentication Real-Time Status