Cisco Systems 8.6 manual Services Guide, Do Not Disturb, Phone Services Configuration

Chapter 5 Configuring Features, Templates, Services, and Users

Telephony Features Available for the Cisco Unified IP Phone

Table 5-1		Telephony Features for the Cisco Unified IP Phone (continued)
	Feature		Description	Configuration Reference
	Do Not Disturb (DND)		When DND is turned on, either no audible rings	For more information, see Cisco Unified
			occur during the ringing-in state of a call, or no	Communications Manager Features and
			audible or visual notifications of any type occur.	Services Guide, Do Not Disturb.
			You can configure the phone to have a softkey
			template with a DND softkey or a phone-button
			template with DND as one of the selected features.
			The following DND-related parameters are
			configurable in Cisco Unified Communications
			Manager Administration:
			• Do Not Disturb—This check box allows you
			to enable DND on a per-phone basis. From
			Cisco Unified Communications Manager
			Administration, choose Device > Phone >
			Phone Configuration.
			• DND Option—Choose “Call Reject” (to turn
			off all audible and visual notifications), or
			“Ringer Off” (to turn off only the ringer).
			DND Option appears on both the Common
			Phone Profile window and the Phone
			Configuration window (Phone Configuration
			window value takes precedence).
			• DND Incoming Call Alert—Choose the type
			of alert to play, if any, on a phone for incoming
			calls when DND is active. This parameter is
			located on both the Common Phone Profile
			page and the Phone configuration page (Phone
			Configuration window value takes
			precedence).
			• BLF Status Depicts DND—Enables DND
			status to override busy/idle state.
	Enbloc Dialing		Enbloc dialing enables SCCP to send all digits of a	1. To disable enbloc dialing, in Cisco
	(SCCP phones only)		phone number simultaneously. This feature must	Unified Communications Manager
			be disabled if either Forced Authorization Codes	Administration, go to Device > Phone.
			(FAC) or Client Matter Codes (CMC) dialing is	2. On the Phone Configuration window, in
			being used.
				the “Product Specific Configuration
				Layout” area, uncheck the “Enbloc
				Dialing” check box, then click Apply
				Config, then click Save.
	Fast Dial Service		Allows a user to enter a Fast Dial code to place a	For more information, see:
			call. Fast Dial codes can be assigned to phone	• Cisco Unified Communications Manager
			numbers or Personal Address Book entries. (See
				Administration Guide, Cisco Unified IP
			“Services” in this table.)
				Phone Services Configuration.
				• Cisco Unified Communications Manager
				System Guide, Cisco Unified IP Phone
				Services.
		Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
	5-10			OL-23091-01