Chapter 4 Configuring Settings on the Cisco Unified IP Phones

Device Configuration Menu

Table 4-19

Network Configuration Menu Options (continued)

 

 

 

 

 

Option

 

Description

To Change

 

 

 

LLDP-MED: SW Port

Enables and disables Link Layer Discovery

From Cisco Unified Communications Manager

 

 

Protocol Media Endpoint Discovery (LLDP-MED)

Administration, choose

 

 

on the switch port. Use this setting to force the

Device > Phone > Phone Configuration.

 

 

phone to use a specific discovery protocol, which

 

 

 

should match the protocol supported by the switch.

 

 

 

Settings include:

 

 

 

Enabled—default

 

 

 

Disabled

 

 

 

 

 

LLDP Asset ID

 

Identifies the asset ID assigned to the phone for

From Cisco Unified Communications Manager

 

 

inventory management.

Administration, choose Device > Phone >

 

 

 

 

Phone Configuration.

 

 

 

Wireless Headset

Enables users to receive notifications of incoming

From Cisco Unified Communications Manager

Hookswitch Control

calls and answer or end calls while working in a

Administration, choose Device > Phone >

 

 

wireless environment.

Phone Configuration.

 

 

 

LLDP Power Priority

Advertises the phone’s power priority to the

From Cisco Unified Communications Manager

 

 

switch, enabling the switch to appropriately

Administration, choose

 

 

provide power to the phones. Settings include:

Device > Phone > Phone Configuration.

 

 

Unknown—default

 

 

 

Low

 

 

 

High

 

 

 

Critical

 

 

 

 

IP Addressing Mode

Displays the IP addressing mode that is available

From Cisco Unified Communications Manager

 

 

on the phone—IPv4 only, IPv6 only, or IPv4 and

Administration, choose Device > Device

 

 

IPv6.

Settings > Common Device Configuration.

 

 

 

IP Addressing Mode

Indicates the IP address version that the phone uses

From Cisco Unified Communications Manager

Preference for

 

during signaling with Cisco Unified

Administration, choose Device > Device

Signaling

 

Communications Manager when both IPv4 and

Settings > Common Device Configuration.

 

 

IPv6 are available on the phone.

 

 

 

Displays one of the following options on the

 

 

 

phone:

 

 

 

Use System Default—The dual-stack phone

 

 

 

 

uses the default system addressing

 

 

 

IPv4—The dual-stack phone prefers to

 

 

 

 

establish a connection via an IPv4 address

 

 

 

 

during a signaling event

 

 

 

IPv6—The dual-stack phone prefers to

 

 

 

 

establish a connection via an IPv6 address

 

 

 

 

during a signaling event

 

 

 

Default: Use System Default

 

 

 

 

 

 

 

 

Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)

 

 

 

 

 

 

OL-23091-01

 

 

4-37

 

 

 

 

 

Page 109
Image 109
Cisco Systems 8.6 manual Settings Common Device Configuration